0


Contact Us








Chart Agent


for email promotions and coupons
Category: Signs/Symbols/Tags/Tapes >> IMO Symbols >> Fire Control >> Without Text >> Assembly Station Sign Pvc 50MM X 50MM W/Text
Assembly Station Sign Pvc 50MM X 50MM W/Text


Assembly Station Sign Pvc 50MM X 50MM W/Text



Qty:  

Assembly Station Sign Pvc 50MM X 50MM W/Text


Ships In 1 to 2 Weeks
$4.49 
Catalog # PR4119EE

The ASSEMBLY / MUSTER STATION SIGN (50MM X 50MM) is a IMO approved safety sign with a self adhesive peel-off backing. Printed in accordance with SOLAS Chapter III, Regulation 9.2.3, Resolution A 752 (18) using Class 'B' Photoluminescent Strontium Aluminate Oxide pigment, these IMO signs glow 10 times longer than those supplied by most other manufacturers and are produced specifically for the commercial shipping industry. A green square or rectangle with white symbols and/or text indicates the locations of escape route or safe condition.

Technical Information:

Photoluminescent Rigid PVC;
Laminated PVC sheet incorporating a photoluminescent layer backed by a rigid white reflective substrate and protected by a tough, clear gloss PVC film. All laminations are thermally welded to form a cohesive sheet;
Thickness: 1.2mm;
Indoor durability: in excess of 5 years;
Outdoor durability: excellent, but can reduce in strong sunlight;
Toxicity: non-toxic, non-radioactive and contains no phosphorous or lead;
Chemical resistance: resistant to most common cleansing agents;
Flammability: inherently fire retardant;
Luminance performance: in excess of 46mcd/m2 @ 10 mins. and 4mcd/m2 @ 60 mins. when tested in accordance with DIN 67510 -1 Part 1.

Installation procedures:

Rigid products -
Rigid signs can be drilled at each corner for mechanical fixing and suspension from the deck head, or can be fixed in place using applied adhesives, double sided adhesive pads or suspension kits.
Where adhesives are used the sign should be temporarily fixed in place using adhesive tape along its top edge so that a hinge is formed. Once this is done flip the sign up to reveal the back and apply the adhesive. Turn the sign back down allowing it to stick to the bulkhead. Apply pressure with a wad of soft cloth and ensure a good contact by adding additional tape until the adhesive has cured.


Recommendations SEE ALL
    No Reviews
Loading...